website Skip to content
Black Friday - Up to 60% Off Plus Extra 20% Off - Code BF20

Search Products

How to Clean Roller Blinds: Easy Step-by-Step Guide

How to Clean Roller Blinds: Easy Step-by-Step Guide

  • by 1ClickBlinds

To clean roller blinds, lower the blind fully and dust it from top to bottom with a soft brush or the brush tool of your vacuum. Then spot clean marks with a cloth dipped in warm water and a little mild washing-up liquid, wrung out until barely damp, and blot rather than rub. Waterproof PVC blinds can be wiped all over. Always let the fabric dry fully, still pulled down, before you roll it back up.

Roller blinds are one of the easiest blinds to keep clean, because the fabric is one flat sheet with no slats or folds. Dust, kitchen grease and the odd fingerprint build up over time, though, and the wrong method can leave water marks or crack a blackout coating. This guide shows how to clean roller blinds step by step, how to treat each fabric type, how to remove common stains, and how to take a roller blind down if you need to.

How to clean roller blinds: the quick answer

  • Every week or two: dust or vacuum with a soft brush attachment on a low setting.
  • Marks: blot with a barely damp cloth and a little mild washing-up liquid.
  • Waterproof PVC: wipe all over with a damp cloth and mild soapy water.
  • Blackout fabric: wipe gently and never fold or crease the fabric.
  • Drying: leave the blind pulled down until it is completely dry.
  • Never: soak the fabric, scrub hard, use bleach or put it in the washing machine unless the care label says you can.

What you need

  • A vacuum cleaner with a soft brush or upholstery attachment, or a feather duster
  • Two or three clean white microfibre cloths, so no dye transfers
  • A bowl of warm water and mild washing-up liquid
  • A soft clean sponge, for waterproof PVC blinds
  • A white rubber eraser or a lint roller, for small marks and fluff
  • A step ladder, if the top of the blind is out of reach

How to clean roller blinds step by step

  1. Check the care label. Look on the bottom bar, the instructions or the product page for any cleaning advice for your fabric.
  2. Lower the blind fully. Pull it all the way down so you can reach the whole fabric and nothing is hidden on the roll.
  3. Dust it. Use a soft brush attachment on a low setting, or a feather duster, and work from top to bottom. Hold the bottom bar with your other hand so the fabric does not swing.
  4. Do the back too. Dust the side facing the window, where condensation and dust often collect.
  5. Mix a mild cleaning solution. Add a few drops of washing-up liquid to a bowl of warm water.
  6. Test on a hidden area. Dab a little on a bottom corner and let it dry, to check the colour and finish do not change.
  7. Spot clean marks. Dip a cloth in the solution, wring it out until barely damp, and blot the mark from the outside in. Do not rub, as this can spread the mark or roughen the fabric.
  8. Rinse. Blot the same area with a clean cloth dampened with plain water to lift any soap.
  9. Let it dry pulled down. Leave the blind fully lowered until it is completely dry. Rolling up a damp blind can cause water marks, creases and mould.

How to clean each type of roller blind

Fabric type How to clean it Avoid
Standard fabric (dimout or light filtering) Dust regularly and spot clean with a barely damp cloth Soaking or scrubbing the fabric
Blackout Dust, then wipe gently with a damp cloth and mild soap Folding, creasing or scrubbing, which can crack the coating
Waterproof PVC Wipe all over with a damp cloth or sponge and mild soapy water Abrasive pads and strong solvents
Sheer and screen Dust gently and blot marks with a barely damp cloth Pulling or rubbing the open weave
Patterned and printed Dust and spot clean lightly, testing first Strong cleaners that can fade the print
Thermal Dust and spot clean, keeping any backing dry Soaking the backing layer

For kitchens and bathrooms, a wipe-clean fabric saves time. See our waterproof blinds.

How to remove common stains from roller blinds

Stain What to do
Dust and cobwebs Vacuum with a soft brush, or use a lint roller on small areas
Kitchen grease Blot with warm water and washing-up liquid, then rinse with a clean damp cloth
Fingerprints and small marks Rub very gently with a clean white rubber eraser, or blot with a barely damp cloth
Coffee or tea Blot straight away with a dry cloth, then dab with mild soapy water
Water marks Dampen the whole area evenly with a clean cloth and let it dry pulled down
Mould spots On PVC, wipe with mild soapy water and dry well. On fabric, test first and blot gently; heavy mould on fabric may mean replacing the blind

Can you wash roller blinds in the washing machine or bath?

We do not recommend it. Most roller blind fabrics are stiffened or coated so they hang flat and roll evenly. Soaking them in a bath or washing machine can soften the fabric, crack a blackout coating, and make the blind roll unevenly or curl at the edges. The roller tube and bottom bar should never be soaked. Spot cleaning is safer for almost every roller blind.

How to take down a roller blind for cleaning

You do not usually need to take a roller blind down to clean it. If you want to clean it on a table, or need to reach a high window, here is how to remove it:

  1. Roll the blind up fully so the fabric is tight on the tube.
  2. Unhook the chain from the chain safety device on the wall.
  3. Find the release. Many brackets have a small clip, button or latch at the end opposite the chain.
  4. Lift out the pin end first. Support the tube with both hands, push or press the release and ease the pin end out of its bracket.
  5. Slide out the control end. Lift the chain end off its bracket and lay the blind flat on a clean surface.
  6. Refit it the same way in reverse: control end first, then click the pin end into place, and refit the chain safety device.

For more help with brackets and refitting, read how to fit roller blinds.

How often should you clean roller blinds?

Room Dust Spot clean or wipe
Bedroom and living room Every two weeks When you see marks
Kitchen Weekly Every month, for grease
Bathroom Weekly Every month, and dry well after showers
Children's room Weekly When you see marks

Tips to keep roller blinds clean for longer

  • Open windows or use an extractor fan when cooking or showering, so steam does not settle on the fabric.
  • Wipe condensation off the glass in the morning so it does not mark the blind.
  • Roll the blind up when you are cooking near the window.
  • Handle it by the bottom bar or chain, not the fabric.
  • Dust little and often, so grime never has a chance to build up.

If the blind will not roll straight after cleaning, see how to fix a broken roller blind. Need a new chain or bracket? Browse our blind spare parts. If it is time for a fresh blind, every one of our roller blinds is made to measure.

Frequently asked questions

How do you clean roller blinds?

Lower the blind fully, dust it with a soft brush or vacuum attachment, then spot clean marks with a barely damp cloth and mild washing-up liquid. Let it dry fully before rolling it up.

Can you clean roller blinds without taking them down?

Yes. Pull the blind all the way down and clean it in place. This is the easiest and safest way for most roller blinds.

Can I put my roller blind in the washing machine?

Not unless the care label says you can. Most roller blind fabrics are stiffened or coated, and machine washing can make them curl, crease or roll unevenly.

How do you clean blackout roller blinds?

Dust them, then wipe gently with a damp cloth and a little mild soap. Do not scrub, fold or crease the fabric, as this can crack the blackout coating.

How do you clean waterproof roller blinds?

Wipe them all over with a damp cloth or sponge and mild soapy water, then dry with a clean cloth. Avoid abrasive pads.

How do you get mould off a roller blind?

On waterproof PVC, wipe with mild soapy water and dry well. On fabric, test a hidden area first and blot gently. Heavy mould on fabric is hard to remove, so keeping the room ventilated is the best prevention.

How do you remove a roller blind?

Roll it up fully, unhook the chain from the safety device, release the clip on the pin end, lift that end out of its bracket and slide the chain end free.

Why does my roller blind have water marks after cleaning?

The cloth was too wet, or only part of the area was dampened. Dampen the whole area evenly with a barely damp cloth and let it dry with the blind pulled down.

How often should I clean my roller blinds?

Dust them every one or two weeks, and weekly in kitchens and bathrooms. Spot clean marks when you see them.

How do I clean other types of blinds?

Each blind needs a slightly different method. Read how to clean perfect fit blinds and shutters.


Welcome offer

A little something
to get you started.

Scratch the panel below to reveal your first‑order discount.

Don't miss your discount